Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

IP Route

Hi All,

I have below route

ip route A.B.C.D 255.255.255.0 E.F.G.H permanent

I would like to modify this route like below

ip route A.B.C.D 255.255.255.0 E.F.G.H distance 40

Please let me know with out any services interruption. How can i change the above configuration?

Thanks in Advance

Madan

4 REPLIES
Bronze

Re: IP Route

Are these static routes dynamically distributed anywhere?

If so, what dynamic protocol are you using and through how many hops will it be distributing?

You may also want to add the interface as an outband perameter as well e.g. A.B.C.D 255.255.255.0 eth0 E.F.G.H distance 40

This helps with any recursive problems of static routes which helps with convergence behaviours

New Member

Re: IP Route

Madan,

add new route in global config, previous route will be overwritten...

Chetan !

Hall of Fame Super Silver

Re: IP Route

Hello Madan,

add the new static route and then remove the old one I think both will be in the configuration.

the new route is a floating static route with AD 40 that can be overriden by eBGP.

If you want to make a floating static route for another protocol use a value of 200.

In this way there shouldn't be service interruption.

Hope to help

Giuseppe

New Member

Re: IP Route

Please ignore my previous post....

i misinterpreted the original question..

Chetan !

100
Views
0
Helpful
4
Replies
CreatePlease to create content