Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
Community Member

ip routing


We recently established a metro link connecting a remote office. Site A is a public network, Site B is a private network. The routers appear to be talking to each other. Site A also has a Cisco 1605R connecting it to the Internet. I ran the following command on it the establish a static route to the router to Site B:

config terminal ip route

However, commands sent to the private network still are being routed to the Cisco.

Am I missing another command somewhere?

Here is the result from a 'show ip route'

united_imaging>show ip route

Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP

D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP

i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area

* - candidate default, U - per-user static route, o - ODR

P - periodic downloaded static route

Gateway of last resort is to network is subnetted, 1 subnets

C is directly connected, Ethernet1

S [1/0] via

S* is directly connected, Serial0

Thank you in advance for you help,


Cisco Employee

Re: ip routing


Could you please send the config for both the routers Router A and Router B. Do a traceroute to 192.168.1.x any host and check where are you going through it.

Also, Please paste a brief network topology.

-amit singh

Community Member

Re: ip routing


Sorry, what exactly are you looking for as far as the topology? I can create a simple diagram if your wish.

Thank you again,


Community Member

Re: ip routing


I attempted to post my 'show config' results to you, but somehow they did not show up on the forum. Can you please confirm whether or not you got them?



Re: ip routing

Try uploading the same again or send me at

Thanks EM

Kindly rate all the post if helpful.

CreatePlease to create content