At my I have core switch (for discussion consider one switch). There are two wan rotuers connected to core switch. One router is connected to SP 1 and other router to SP 2. Both these CE routers are running BGP with service provider and static routing towards LAN (core switch).
Now the core switch need to do ECMP using reliable static routing. I know a dynamic routing is the solution but I have reservations. We have decided to go for IP SLA based load balancing from core to WAN routers. The question here is if one of the Spoke location SP 1 link is down, the switch should not forward traffic for that LAN to the affected edge router ?
what is the possible option. Is it an iBGP between two routers ?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...