cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
219
Views
0
Helpful
1
Replies

IP SLA not injecting tracked route

neilobrien
Level 1
Level 1

Hi People,

I have a router which has 2 ISP connections into it. I have configured an IP SLA to ping an address out the primary ISP interface and install a default route when reachability is up.

The problem is, the reachability status is up, the IP SLA stats are showing successful but it's not installing the tracked route.

See config below:

IP SLA Config to ping 213.94.190.194

CH-BARROW-CMERTR01#sh run | se ip sla

track 1 ip sla 1 reachability

delay down 10

ip sla 1

icmp-echo 213.94.190.194 source-interface FastEthernet0/0

timeout 3000

frequency 3

ip sla schedule 1 life forever start-time now

Shows results as successful

CH-BARROW-CMERTR01#sh ip sla stat

IPSLAs Latest Operation Statistics

IPSLA operation id: 1

Latest RTT: 16 milliseconds

Latest operation start time: 08:42:03.490 BST Tue Jul 21 2009

Latest operation return code: OK

Number of successes: 976

Number of failures: 0

Operation time to live: Forever

Shows track opject as up

CH-BARROW-CMERTR01#sh track 1

Track 1

IP SLA 1 reachability

Reachability is Up

3 changes, last change 02:22:46

Delay down 10 secs

Latest operation return code: OK

Latest RTT (millisecs) 20

Tracked by:

STATIC-IP-ROUTING 0

configured routes from running config, primary ISP as tracekd route and secondary ISP with AD of 20. Static route to 213.94.190.194 to ensure it goes out the correct interface

CH-BARROW-CMERTR01#sh run | se ip route

ip route 0.0.0.0 0.0.0.0 83.147.185.1 track 1

ip route 0.0.0.0 0.0.0.0 Dialer1 20

ip route 172.20.104.253 255.255.255.255 Service-Engine0/0

ip route 192.168.0.0 255.255.255.0 192.168.104.253

ip route 213.94.190.194 255.255.255.255 FastEthernet0/0

Shows default route as the dialer to the secondary ISP

Gateway of last resort is 0.0.0.0 to network 0.0.0.0

C 192.168.104.0/24 is directly connected, FastEthernet0/1.10

86.0.0.0/32 is subnetted, 1 subnets

C 86.43.118.190 is directly connected, Dialer1

83.0.0.0/8 is variably subnetted, 2 subnets, 2 masks

S 83.147.160.9/32 [254/0] via 83.147.185.1, FastEthernet0/0

C 83.147.185.0/24 is directly connected, FastEthernet0/0

159.134.0.0/32 is subnetted, 1 subnets

C 159.134.155.19 is directly connected, Dialer1

172.20.0.0/16 is variably subnetted, 2 subnets, 2 masks

S 172.20.104.253/32 is directly connected, Service-Engine0/0

C 172.20.104.0/24 is directly connected, FastEthernet0/1.20

S 192.168.0.0/24 [1/0] via 192.168.104.253

213.94.190.0/32 is subnetted, 1 subnets

S 213.94.190.194 is directly connected, FastEthernet0/0

S* 0.0.0.0/0 is directly connected, Dialer1

shows the tracked route as up

CH-BARROW-CMERTR01#sh ip route track-table

ip route 0.0.0.0 0.0.0.0 83.147.185.1 track 1 state is [up]

CH-BARROW-CMERTR01#

The strange thing is that I have similar config on other sites and they're working fine (I hope) so any advise from a fresh set of eyes would be appreciated.

Thanks in advance,

Neil

1 Reply 1

neilobrien
Level 1
Level 1

anyone??

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card