Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

ip sla not work

Gentlemen,

I have cisco 2911 with IOS-universalK9 mz.SPA.150.1.T, but that does not accept the ip sla monitor commands XX, XX or rtr ip sla XX.

How active these commands in IOS or what you belong to?

Tks

Andre E Biliati

Everyone's tags (3)
1 REPLY

Re: ip sla not work

You're going to need a different IOS version. The Universal IOS is licensed based off of what features you want. You'll need , at minimum, the data version and not the base version. If you do a "sh ver" on your router, you'll notice a table of features. If they say none by the item in the "Technology" column, then your IOS doesn't support those features. So, in the data row, you should have "datak9  Permanent  datak9". If you have none in all 3, then you need an upgrade.

HTH,

John

HTH, John *** Please rate all useful posts ***
488
Views
0
Helpful
1
Replies
CreatePlease to create content