03-09-2008 10:46 AM - edited 03-03-2019 09:02 PM
HI
How to configure the following IP SLA:
configure ip sla udp jitter operatio number 10 will start in 1 hours and run foreever
destination IP:172.16.1.100
PORT :2000
AFTE FINISHING CONFIGURATION WILL START INTANTLY
10XS
Solved! Go to Solution.
03-09-2008 11:59 AM
ip sla monitor 10
type jitter dest-ipaddr 172.16.1.100 dest-port 2000 num-packets 20
request-data-size 160
tos 128
frequency 30
ip sla monitor schedule 10 start-time after 01:00:00
On the target destination device, you need
ip sla monitor responder
03-09-2008 11:43 AM
Hi Ali,
Please check out the documentation:
http://www.cisco.com/en/US/docs/ios/12_4/ip_sla/configuration/guide/hsjitter.html
HTH,
__
Edison.
03-09-2008 11:49 AM
edy long time ya man!
plz upload the config accordignly
10xs
03-09-2008 11:59 AM
ip sla monitor 10
type jitter dest-ipaddr 172.16.1.100 dest-port 2000 num-packets 20
request-data-size 160
tos 128
frequency 30
ip sla monitor schedule 10 start-time after 01:00:00
On the target destination device, you need
ip sla monitor responder
03-09-2008 12:23 PM
10xs edi
03-09-2008 01:22 PM
10xs edy
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: