Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP Unnumbered help

Hi Guys

I am a beginner - but i hope you can help.

I have two routers,

Router 1 - has 2 serial cards and an ethernet connection. Serial 1 is using ip unnumbered GigabitEthernet0/0 to the ISP, I want to send the traffic from router 2 via serial 2 to this router, to the isp.

I have configured basic routing between the two routers on serial 2 but i dont think its working as they want. Could i do ip unnumbered on router 2 ??

Any ideas ?

2 REPLIES
Bronze

IP Unnumbered help

Dear Nuno,

Thank you for reaching Small Business Support Community.

What are the routers models you attempt to setup on your case scenario?

Thank you for your time and patience,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.

Jeffrey Rodriguez S. .:|:.:|:. Cisco Customer Support Engineer *Please rate the Post so other will know when an answer has been found.
Silver

IP Unnumbered help

Hi Nuno,

Can you please clarify a bit more what do you want to achieve? It is not very clear in your post: "i dont think its working as they want".

Do you want to have just Ip connectivity between the two routers? are you going to run a routing protocol between these two routers?

Anyway, in order to obtain reachability you need to add a static route in both routers, like this:

In R1

ip route 2.2.2.2 255.255.255.255 Serial1/0 2.2.2.2

Where 2.2.2.2 is the Ip address of R2

In  R2

ip route 1.1.1.1 255.255.255.255 Serial1/0 1.1.1.1

Where 1.1.1.1 is the Ip address of R1

Best Regards,

Jose.

256
Views
0
Helpful
2
Replies
CreatePlease login to create content