Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ip verify unicast reverse-path

Hi Expert,

I have Configuration as below,

pun-rtr-tpap0102#sh ip int brief
Interface                  IP-Address      OK? Method Status                Prot                                                                             ocol
GigabitEthernet0/0         172.21.7.137    YES NVRAM  up                    up                                                                              
GigabitEthernet0/1         unassigned      YES NVRAM  administratively down down                                                                            
ATM1/0                     unassigned      YES NVRAM  up                    up                                                                              
ATM1/0.103                 unassigned      YES unset  up                    up                                                                              
Virtual-Access1            unassigned      YES unset  up                    up                                                                              
Virtual-Access2            unassigned      YES unset  down                  down                                                                            
Virtual-Access3            unassigned      YES TFTP   up                    up                                                                              
Virtual-Access4            192.168.2.2     YES TFTP   up                    up                                                                              
Virtual-Template10         192.168.2.2     YES NVRAM  down                  down                                                                            
pun-rtr-tpap0102#sh run
pun-rtr-tpap0102#sh running-config in
pun-rtr-tpap0102#sh running-config interface ATM1/0
Building configuration...

Current configuration : 97 bytes
!
interface ATM1/0
no ip address
no ip redirects
load-interval 30
no atm ilmi-keepalive
end

pun-rtr-tpap0102#sh running-config interface ATM1/0.103
Building configuration...

Current configuration : 185 bytes
!
interface ATM1/0.103 point-to-point
pvc aap 1/103
  vbr-rt 2200 2200
  oam-pvc manage
  encapsulation aal5snap
  max-reserved-bandwidth 95
  protocol ppp Virtual-Template10
!
end

pun-rtr-tpap0102#
pun-rtr-tpap0102#sh run
pun-rtr-tpap0102#sh running-config in
pun-rtr-tpap0102#sh running-config interface Virtual-Access4
Building configuration...

Current configuration : 268 bytes
!
interface Virtual-Access4
bandwidth 2200
ip address 192.168.2.2 255.255.255.252
ip tcp header-compression iphc-format
load-interval 30
delay 999
service-policy output voice-policy
ip rtp header-compression iphc-format
ip rtp compression-connections 100
end

pun-rtr-tpap0102#sh running-config interface Virtual-Access1
Building configuration...

Current configuration : 48 bytes
!
interface Virtual-Access1
no ip address
end

pun-rtr-tpap0102#

Pl's help me to configure ip verify unicast reverse-path under Virtual-access 4 .

239
Views
0
Helpful
0
Replies
CreatePlease to create content