1. Can I use same IP tunnel r1 - r2 on framereley 1 for network r3 in way of setting r3 network in access list that i set for r1 -r2 tunnel.
After this I want to set the new tunnel with the peers r2 and r3 on frame relay2 link to encrypt traffic between r2 and r3.
Does this scenario is OK. Will the packet that is from r1 to r3 network be encrypted on r1 and than decrypted on r2 than again encrypted on r2 and then decrypted on r3?
Is this better than make new tunnel between r1 and r3 with the peers r1 and r3? In this case how to set 2 crypto maps on r1 on the same interface, one for tunell between r1 nad r2 and one for r1 and r3.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...