this is my config, trying to failover using WAN links between two sites , two c3750x one at each site. connected to Internet via Watcghuard XTM 505 devices and connected to each other for WAN -point to point link, that i want to use for failover.
it does failover but for some reason internet goes dead after every 30 seconds for around 30 seconds then comes on for 30 seconds and goes down after 30 seconds, its like a loop.
not sure what i am missing in config.
track 1 ip sla 1 reachability delay down 30 up 30 ! track 2 ip sla 2 reachability delay down 30 up 30
what if I define IP address on Interfaces for router uplink and point to point lines, instead of using VLANs for these two links. and not sure if can define interface to use in ipsla command. somehow need to restrict ipsla icmp to go out only via one route.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...