I'm trying to do some testing with IP SLA and Enhanced Object Tracking and came up with a problem with the commands. I am using a 12.4(15)T7. From the track commands, I want to test the reachability of a host using "track 1 rtr 1 reachability" command. However, the rtr command isn't available now and it was already replaced by "ip sla" command. When I looked for "track 1 ip sla" command, it's not there, only track 1 ip route" is there.
My question is, will it work if I create a configuration like "ip sla 1" then apply it as "track 1 rtr 1"? Is that basically the same? Will the IOS treat the rtr as ip sla too? Thanks in advance.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...