I'm trying to enable DHCP relay on the GigabitEthernet port on device CRS. The CRS should act as DHCP relay device however, when configuring ipv4 helper-address command under the interface, the command "show ipv4 int gi0/2/2/6" shows that helper address is not set. I tried to enable dhcp service on the whole box by entering the command "dhcp server" but without any luck. I would be grateful if someone could help in this matter. Thank you for your help, Susanne
Thank you for your answer. However, this is a CRS, XR software, box and to turn on DHCP you enter the command "dhcp server". The command "service dhcp" does not exist in XR 3.4 software. I would appreciate if someone knows how to turn it on. Following commands has been entered:
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.