IPv4 Nat translations?

[juwairiyeh900501324]

Hi guys,

If NAT is configured on a boundary router and is set on the inside and outside interfaces, but show ip nat translations doesn't show any information.

Why might the problem be?

[AJ Cruz]

Either your traffic isn't getting routed to the router or the NAT config has an error. Can you post the relevant configuration?

Sent from Cisco Technical Support iPad App

[juwairiyeh900501324]

NAT config"

ip nat pool POOL1 1.1.0.0 1.1.0.255 prefix-length 16

ip nat inside and outside are set to the interfaces as well.

[Ali Bahnam]

Hi,

Your NAT is incomplete please try this:-

ip nat pool POOL1 1.1.0.0 1.1.0.255 prefix-length 16

access-list xx permit (internal traffic)

ip nat inside source list xx pool POOL

Please let us know if this solving your issue.

Regards,