I need some help with an ipv4 to ipv6 nat. I can get it working 1 to 1, pc on ipv4 going to router with v4v6 nat and v6v4 nat, then to router with ipv6 address. What i am trying to do is have 1 server poll multiple ipv6 devices. So i setup a separate ipv4 address for each device and nat it to the ipv6 address. However this doesnt work, not sure if it is because the ipv4 doesnt actually belong to any interface. Does anyone any other options to have an ipv4 server poll multiple ipv6 devices?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...