At the outset i thank you very much for your post. It helped me a lot. I tried your configuration & it is working perfectly.
From IPV4 (ISATAP Client)with IP address 192.168.1.2 iam able to ping remote IPV6 machine with ip address 2001:a:b:c::2.
But i am not able to telnet the IPV6 Machine from IPV4 (ISATAP Client). After adding the default route ::/0 200:3def:5efe:c0a8:0102 (ISATAP server Tunnel interface IP), i am able to telnet to the remote IPV6 machine.
I am surprised why is this behaviour of able ping and not telnet the remote IPV6 machine. But why i am able to telnet the same IPV6 Machine from IPV4 (ISATAP Client) after adding the ipv6 default route with gateway as tunnel ISATAP ipv6 address.
What level of code are you using on the ISATAP client? I just tried with 12.4(24)T and I can ping and telnet to the rest of the network. You shouldn't need to configure a default route on the router used as a client just as you do not need to configured a default route on a regular client as in IPv6 the default router is discovered dynamically via the RA messages.
You should see the following information on the ISATAP client:
ISATAP-client#sh ipv6 router
Router FE80::5EFE:C0A8:C02 on Tunnel0, last update 8 min
As you adviced i tried the same. I attached configuration of ISATAP server and Client configuration for your reference.
But the result is same. Until i configure the default route with gateway as ISATAP server Tunnel IP Address in the client, I am able to ping the remote IPV6 Machine and not TELNET the same machine. I am using IOS Version 12.4(25).
Can you please look into the configuration and help me
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...