Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IPv6 Multicast Replication Mode

I got the following from Cisco Error Message Decoder.

Question: Does this mean "all" traffic will stop flowing, or just Multicast traffic? Or, just the module of concern?

. %MLSM-6-MMLS_MODE_CHANGE: MMLS: Replication Mode Change Detected

This message indicates that, when automatic detection of the replication mode is enabled, the system will transition to ingress mode when an egress-incapable module is inserted. The system will transition back to egress mode when the last egress-incapable module is removed.

Recommended Action: Transitioning between ingress and egress mode causes a temporary loss of traffic. To prevent this temporary loss of traffic, enter the mls ip replication-mode ingress command.

1 REPLY
Silver

Re: IPv6 Multicast Replication Mode

This condtion applies only for multicast traffic and this is a Multicast Distributed Shortcut Switching (MDSS)/multilayer switching for multicast (MLSM) messages.

129
Views
0
Helpful
1
Replies