HI - have been running IPv6 traffic from Ixia thu our 3845 on a 1gig copper interface. If I do more than 25% I get packet loss and the CPU on the Cisco is over 80%. Do I need to make some configuration changes, or is the 3845 too "small" for IPv6? Any help appreciated.
With packet size = 68, it is expected that CPU will be maxed out before line rate. Normally testing will be done with different packet size from and average internet packet size is expected to be around 350 - 400 bytes.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...