Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

ipv6 on Cisco 2811

Hi ,

Cisco Feature navigator says it supports IPv6 on following IOS & Model.

System image file is "flash:c2800nm-advsecurityk9-mz.124-15.T7.bin"

Cisco 2811 (revision 53.51) with 249856K/12288K bytes of memory.

But

i cannot run "ipv6 unicast-routing" command

also i am not able to assign ipv6 addresses to any of the interfaces. !!!

Anybody has any idea ? in fact it does not give me any ipv6 option from CLI ( neither privilege nor global config )

Also , can i run DHCP for IPv6 on Cisco 2811 router with above IOS ?

3 REPLIES
Cisco Employee

Re: ipv6 on Cisco 2811

Satish,

I just checked the Feature Navigator and it actually says that you either need ADVANCED ENTERPRISE SERVICES or ADVANCED IP SERVICES to run ipv6 on the 2811. ADVANCED SECURITY SERVICES will not do it.

Regards

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México

Re: ipv6 on Cisco 2811

Yeah , i checked it again , you are right...

:)

Thanks

New Member

i just ran into the same

i just ran into the same thing....  

12.2(10a) won't run it on a 2600 either?.... 

3706
Views
0
Helpful
3
Replies
CreatePlease to create content