I tried to configure IPV6 RIP over FR, and i exeperienced wierd thing, I just enabled ipv6 rip and ipv6 without FR mapping, but it works fine OKed ping and OKed rouging table. it was FR main interface and no frame-relay interface-dlci xxx .... at all. Any explain?
I think that neither RIPnG nor RIPv1/2 need frame-relay map statements to work; by default, all DLCIs are assigned to the physical frame relay interface, so if you have no subinterfaces, and inverse arp is enabled (which is the default), the RIP neighbors should be established automatically...
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...