guys today i came across a wierd exercise......there are two router connected togather via FR line....now the address to be config is 4588:jhg:tre::/64 and it shd be in eui-64 format.....now remaining part of the ipv6 subnet shd be taken from the third octat of the serial interface.....now the problem is both router s on are same address 192.168.1.0/30 now i am confuse abt both routers serial address third octact is 1 so it means that the ipv6 address will look like
4588:jhg:tre:1::/64 eui-64 am i doing wrong or its something with ipv6....as how come both interface on serial which is connected via FR will have same ip address guys can someone help me abt this whats the right way to do it.....thanks guys
IPv6 eui-64: 64 bits of network part, 64 bits of host part
host part: 64 bits derived from a MAC address on the router with some changes
network part: it is 64 bits and has to be the same so the original request in your exercise is correct because they ask you to set part of the network section not the host portion so it is necessary to use the same value on both routers or they will be in two different /64 IPv6 subnets
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.