Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

is-is requirments

Hi, I am taking BSCI course. I am try to find minimum requirement to run isis on old 2600 routers I have for a lab. I have been looking around Cisco's site, searched is. Can find a lot of info about is but not requirements to run. I can enable router isis but it will not accept network command. Below is what my routers have.

Thanks, Doug

System image file is flash:aaa0224.bin

32K bytes of non-volatile configuration memory.

8192K bytes of processor board System flash (Read/Write)

7 REPLIES
Hall of Fame Super Silver

Re: is-is requirments

Hello Doug,

>> I can enable router isis but it will not accept network command

I would be surprised if it would be supported:

IS-IS doesn't use network command

on interface configuration where you want to run is-is use

int type x/y

ip router isis

do it on all interfaces including loopbacks

Hope to help

Giuseppe

New Member

Re: is-is requirments

Setup from lab book;

router isis

net 49.0001.1111.1111.1111.00

int fa0/0

ip router isis

After I enable isis on the router, when I try the next line is were I have my problem. I get ^ under net as unrecognized command.

Thanks, Doug

Cisco Employee

Re: is-is requirments

Hi Doug,

I saw you have only 8M of Flash so you can use only 12.0 version but you need service-provider or enterprise-plus feature pack which both require 24M of RAM.

HTH

Laurent.

New Member

Re: is-is requirments

Thanks for the info. Would you know where I could find that kind of information? I have been looking over Cisco's site. I am thinking it is because it is older not much ifno is available.

Doug

Cisco Employee

Re: is-is requirments

Hi Doug,

The feature navigator was created for that purpose:

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

HTH

Laurent.

New Member

Re: is-is requirments

Thanks for the link and all the help.

Doug

Hall of Fame Super Silver

Re: is-is requirments

Hello Doug,

in some old releases like 12.0 you need to enable clns routing to use the net command because the net is actually a CLNS address given to the node.

try

conf t

clns routing

router isis

net

This should help

hope to help

Giuseppe

190
Views
0
Helpful
7
Replies