Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Is it possible to install SDM on old CISCO 2610?

Hello all,

I have CISCO 2610 (not "XM" series) and NM4-E module for my labs. Is it possible to install SDM on it?

Extra info:

Bridgecom2610#sh ver

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-IPBASE-M), Version 12.3(9c), RELEASE SOFTWARE (fc 2)

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Tue 30-Nov-04 23:51 by kellythw

Image text-base: 0x80008098, data-base: 0x80F1D424

ROM: System Bootstrap, Version 11.3(2)XA2, PLATFORM SPECIFIC RELEASE SOFTWARE (f

c1)

Bridgecom2610 uptime is 1 hour, 59 minutes

System returned to ROM by power-on

System image file is "flash:c2600-Ipbase-mz.123-9C.bin"

cisco 2610 (MPC860) processor (revision 0x200) with 39936K/9216K bytes of memory

.

Processor board ID JAB0221001C (598769124)

M860 processor: part number 0, mask 32

Bridging software.

X.25 software, Version 3.0.0.

5 Ethernet/IEEE 802.3 interface(s)

4 Serial(sync/async) network interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

Thank you!

2 ACCEPTED SOLUTIONS

Accepted Solutions
Silver

Re: Is it possible to install SDM on old CISCO 2610?

http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet0900aecd800fa5be.html

SDM support seem to be only 2610XM routers.

I also checked up the software advisor, SDM support only on 2610XM not on 2610.

HTH

Hoogen

Do rate if i have helped :)

Cisco Employee

Re: Is it possible to install SDM on old CISCO 2610?

Hello, its not supported on 2600 routers. Its only supported on 2600XM series.

http://www.cisco.com/en/US/products/sw/secursw/ps5318/prod_installation_guide09186a00803e4727.html#wp37069

HTH,Please rate if it does.

-amit singh

2 REPLIES
Silver

Re: Is it possible to install SDM on old CISCO 2610?

http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet0900aecd800fa5be.html

SDM support seem to be only 2610XM routers.

I also checked up the software advisor, SDM support only on 2610XM not on 2610.

HTH

Hoogen

Do rate if i have helped :)

Cisco Employee

Re: Is it possible to install SDM on old CISCO 2610?

Hello, its not supported on 2600 routers. Its only supported on 2600XM series.

http://www.cisco.com/en/US/products/sw/secursw/ps5318/prod_installation_guide09186a00803e4727.html#wp37069

HTH,Please rate if it does.

-amit singh

616
Views
5
Helpful
2
Replies
CreatePlease login to create content