10-18-2006 06:37 PM - edited 03-03-2019 02:24 PM
I'm trying to set up a tiny network between 4 buildings using 828s at each building with a 6015 joining them. I have no need to go anywhere other than between the 828s (no uplink to the rest of our network, or the internet for that matter). All I can get my hands on at this point are the four 828s and the 6015, so I have no ATM uplink... Is this something I can overcome? Suggestions would be GREATLY appreciated! Thanks!
10-24-2006 11:37 AM
ATM uplink is used as Interface between Local LANs and ATM network.If there is no need for Internet access or remote access ATM uplink is not needed.
10-24-2006 11:49 AM
Hi Levi,
Could you please elaborate the matter a bit more. I guess its 828 G.HDSL which is connected to a Service Provider or something which gives an HDSL link to the 6500 Switch.
Moreover what module you are trying to connect to on 6500?
Regards,
Wilson Samuel
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide