Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IS IT The looping

Hi,

I am try to ping my remote site, in which we have Site to site VPN Tunnel betwee our office.

ping result is Reply from 192.168.103.254: TTL expired in transit. & please find the trace result

1 ACCEPTED SOLUTION

Accepted Solutions

Re: IS IT The looping

You have to have you routing planned, you must decide how you want to route your traffic - static routes or dynamic routing.

Once you plan - then you implement.

HTH>

8 REPLIES

Re: IS IT The looping

Yes - you have a loop, you need to check the 2 layer 3 routing devices for overlapping config.

HTH>

New Member

Re: IS IT The looping

Yes,

You are right, can u please tell how to overcome this isssues in future

Re: IS IT The looping

You have to have you routing planned, you must decide how you want to route your traffic - static routes or dynamic routing.

Once you plan - then you implement.

HTH>

New Member

Re: IS IT The looping

Thx for ur time

Re: IS IT The looping

np - glad to help.

New Member

Re: IS IT The looping

Yes,

You are right, can u please tell how to overcome this isssues in future

New Member

Re: IS IT The looping

Can you add the output of a show ip route on both the devices with IP address 192.168.103.1 and 192.168.103.254, and a show run for both devices?

- Thomas

New Member

Re: IS IT The looping

Andrew was right, there was a looping in my l3 switch(103.1).

I fixed the same

thx for ur reply

128
Views
0
Helpful
8
Replies