My 4948 powers up, but the fans do not run at full speed. The status led flashing green. No other leds are orange or red. Nothing prints to the console. The switch port leds jump around as if it were telling a hardware tech where it got stuck. Led sequence is:
Ports 5,7, 12,13 21,23, 31, 39, 44, 45 light up. There is pattern here, so this looks normal. Status light blinks.
Then these leds sequence as follows
2->5->6. Led 6 says on and status light blinks. No port initialization takes place (ports 1-48 do not flash on and off).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...