Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Is password-recovery works on router turn on with radius??

/message/3036844;jsessionid=AB2E3193D00FC98600C816D2BB58780E.node0#3036844Hi Experts,

I have turn on AAA to enable radius authentication. However, I failed to login using the generated password by radius server, which end up I can't log into the router at all. To access this router again, I disconnected the router from LAN and tried using password-recovery measure but still fail. During password-recovery process, I have pressed ctrl+break couple of time but still fail to enter the romon mode.I've been doing this process more than 20 times but seems no use at all. Fyi, I m using router 2811. Really appreciate your advice on how to recover the password again.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Is password-recovery works on router turn on with radius??

1.  Power off the 2811 router.
2.  Pop the CF.
3.  Turn on the router and wait until it boots into ROMmon.
4.  Insert the CF but DO NOT BOOT yet.
5.  Perform password recovery and boot the router.

3 REPLIES
Hall of Fame Super Gold

Re: Is password-recovery works on router turn on with radius??

1.  Power off the 2811 router.
2.  Pop the CF.
3.  Turn on the router and wait until it boots into ROMmon.
4.  Insert the CF but DO NOT BOOT yet.
5.  Perform password recovery and boot the router.

New Member

Re: Is password-recovery works on router turn on with radius??

THANK YOU!

Hall of Fame Super Gold

Re: Is password-recovery works on router turn on with radius??

Thank you for the ratings and glad to be of some assistance.

162
Views
0
Helpful
3
Replies
CreatePlease login to create content