Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Is the HWIC-1FE compatible with 3745?

Hi, I need another Layer 3 fast ethernet port on my 3745 router.

Can anyone pls advice if this is feasible or if there are similar solutions.

Also, what are the IOS versions and standards needed if it is compatible ?

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Silver

Re: Is the HWIC-1FE compatible with 3745?

Hello Meng,

HWICs are supported on ISR routers 1800,2800 and 3800.

you should look for a Network Module the same that were used on C3600 series.

you can use sotware advisor tool to check what IOS is suitable for your hardware and it can provide also the exact name of the network module you are looking for.

Hope to help

Giuseppe

Hall of Fame Super Gold

Re: Is the HWIC-1FE compatible with 3745?

Hi Meng,

Giuseppe is correct. HWIC is not compatible with a 3745 router. You should be looking at the NM-1FE or NM-2FE.

2 REPLIES
Hall of Fame Super Silver

Re: Is the HWIC-1FE compatible with 3745?

Hello Meng,

HWICs are supported on ISR routers 1800,2800 and 3800.

you should look for a Network Module the same that were used on C3600 series.

you can use sotware advisor tool to check what IOS is suitable for your hardware and it can provide also the exact name of the network module you are looking for.

Hope to help

Giuseppe

Hall of Fame Super Gold

Re: Is the HWIC-1FE compatible with 3745?

Hi Meng,

Giuseppe is correct. HWIC is not compatible with a 3745 router. You should be looking at the NM-1FE or NM-2FE.

642
Views
0
Helpful
2
Replies
CreatePlease to create content