Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Is the NM-1CE1T1-PRI the correct card for a frame circuit in a 2811 router?

Hello,

I have a 2811 router and a NM-1CE1T1-PRI card. Is this the correct card for a frame cirucit? I have the card installed but I don't see a serial interface for it. Show ver does show the card:

1 Channelized (E1 or T1)/PRI port

I'm thinking I have the wrong card. But I'm not sure.

Thanks

Mike

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Is the NM-1CE1T1-PRI the correct card for a frame circuit in

It's fine. configure:

controller t1 x/y

channel-group 0 timeslots 1 24

the serial interface will appear and configure you FR in there.

Hope this helps, please rate post if it does!

5 REPLIES
Hall of Fame Super Gold

Re: Is the NM-1CE1T1-PRI the correct card for a frame circuit in

It's fine. configure:

controller t1 x/y

channel-group 0 timeslots 1 24

the serial interface will appear and configure you FR in there.

Hope this helps, please rate post if it does!

New Member

Re: Is the NM-1CE1T1-PRI the correct card for a frame circuit in

Thanks for the help... I see the serial interface now. In you example above channgel-group 0 timeslots 1 24. I could not put in the "24" Not sure I thats a big deal or not.

Hall of Fame Super Gold

Re: Is the NM-1CE1T1-PRI the correct card for a frame circuit in

Ok, I missed a needed dash. Do:

interface x/0:0

shutdown

controller t1 x/0

no channel-group 0 timeslots 1

channel-group 0 timeslots 1-24

and you should be fine.

Thanks for the nice rating and good luck!

Paolo

New Member

Re: Is the NM-1CE1T1-PRI the correct card for a frame circuit in

Paolo,

Some very stragge happen on the router. The command controller from config t is no longer there. I'm not sure what happen, any ideas?

New Member

Re: Is the NM-1CE1T1-PRI the correct card for a frame circuit in

Paolo,

I figured out what happen. the command "card type" was missing. Not sure why. But once I put that back in the controller command was available.

Thanks again

Mike C.

146
Views
0
Helpful
5
Replies