Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Is there a "ip tcp adjust-mss" equivalent command for NX-OS

Hey Community,

Is there a "ip tcp adjust-mss" equivalent command for the NX-OS? We have a few GRE tunnels and best-practice is to configure this command on both ends but the command is not there. 

Please help!

Thanks,

John

Everyone's tags (1)
1 REPLY

Hi,You can use following

Hi,

You can use following configuration instead of former command:

 

#interface tunnel 0

-if)#mtu 1600

-if)#ip access-group DLP in

-if)#ip address <><>

 

#ip access-list extended DLP

-acl)#statistics per-entry

-acl)#deny ip any any packet-length gt <adjust value>

-acl)#permit ip any any

 

I think, it may helps you.

 

Houtan

433
Views
0
Helpful
1
Replies