Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Is there a way to configure ethernet load balancing?

I have two (pairs)of 2811 routers, I want to load balance acrossed them. I've configured hsrp so one pair is primary and the second pair is primary on the other end. (crossover connectd) It will work this way, just not quite right, loose pings, serials not real balanced.

I want a virtual address between the two ethernet ip addresses to use as a gateway address and the routers to equally share the address. (or any suggestions to balance accross the serial links).

Jack

1 REPLY

Re: Is there a way to configure ethernet load balancing?

Hi

did u check out something inline with GLBP instead of having different groups with HSRP ??

if nope then do check this link out for more info on the same..

http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a008042fb97.html

regds

112
Views
0
Helpful
1
Replies
CreatePlease to create content