Is this possible without PBR - Routing from Specific Host to Any
I have an issue where I don't currently have PBR options on my core switch. Now I know I can amend the SDM template and enable the routing one then reboot (I'm also runing ipservices). At the moment though this is not an option.
I have a host - 10.44.129.34 /24 which is a VM.
Current Gateway is 10.44.129.1 which is SVI on our Core.
On the Core I'm looking to say - anything from this specific host going to any remote network - use gateway 10.44.157.6. Is there a way for me to achieve this without PBR?
I cannot amend the IP of the host IP either due to licensing issues with the software I can;t think of a way to do this without PBR.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...