Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

is this the correct config-reg setting?

following is a copy of sh redunancy of m 4510R, I just reset the config register to 0x102, is this setting correct for it to comeback up at reboot? (0x102) it is the default at bootup isnt it?...

BOOT =bootflash:cat4000-i9s-mz.122-25.ewa4.bin,1;

BOOTLDR = bootflash:cat4000-i9s-mz.122-25.ewa4.bin

Configuration register = 0x2101 (will be 0x102 at next reload)

thanks

rdavis

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: is this the correct config-reg setting?

hello Rob,

yes the config-register command changes the value but not on the fly but at next reload you have changed to 0x102 as desired.

This is normal for config-register in all platforms. (change takes effect at next reload)

Hope to help

Giuseppe

2 REPLIES
Hall of Fame Super Silver

Re: is this the correct config-reg setting?

hello Rob,

yes the config-register command changes the value but not on the fly but at next reload you have changed to 0x102 as desired.

This is normal for config-register in all platforms. (change takes effect at next reload)

Hope to help

Giuseppe

New Member

Re: is this the correct config-reg setting?

Thank You

133
Views
0
Helpful
2
Replies