Sorry for the delay in getting back to you, I was travelling home, and only just picked up your post.
Int Bvi1 will be the logical interface for your bridge-group 1. You will assign the IP address for your Vlan 1 / wireless network to this interface. You will assign both the interface vlan 1 and interface dot11Radio0 to this bridge-group.
Create the dot11 ssid mynet globally, and apply the authentication commands etc to this, then under int dot11Radio 0 you will assign this ssid, and the encryption method you are going to use. I just put AES in as an example.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...