Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN Backup on GRE interface with dynamic protocol.

Hi all,

I am trying to configure ISDN backup for a client. The scenario is as follows:

Remote branch is connected through Metro ethernet with edge router A. Routing protocol is OSPF and everything is tunneled through a GRE tunnel.

I need to configure ISDN backup in which the same remote router will call to edge router B. Not only that i will need a full OSPF table (due to some multicast applications that are running) and a time-based ACL.

I have tried to simulate this on the lab using 2x 1841 routers. The configuration is as follows:

Router1: Remote router (caller)

------------------------------------------------

version 12.4

service timestamps debug datetime msec

service timestamps log datetime msec

no service password-encryption

!

hostname TWO

!

boot-start-marker

boot system flash flash:c1841-advipservicesk9-mz.124-24.T1.bin

boot-end-marker

!

logging message-counter syslog

enable password cisco

!

no aaa new-model

clock timezone EET 2

clock summer-time EEST recurring last Sun Mar 3:00 last Sun Oct 3:00

dot11 syslog

ip source-route

!

!

ip dhcp excluded-address 10.6.6.1

!

!

!

ip cef

no ipv6 cef

ntp server 192.168.255.2

!

multilink bundle-name authenticated

!

isdn switch-type basic-net3

isdn tei-negotiation first-call

!

!

!

!

username cisco password 0 cisco

username ONE password 0 cisco

username TWO password 0 cisco

archive

log config

  hidekeys

!

!

!

!

!

!

track 1 ip sla 1 reachability

!

!

!

interface Loopback0

ip address 10.2.2.2 255.255.255.255

!

interface Tunnel1

ip address 10.4.4.2 255.255.255.0

ip ospf network point-to-point

keepalive 10 3

tunnel source FastEthernet0/1

tunnel destination 10.3.3.1

!

interface FastEthernet0/0

description LAN

ip address 10.6.6.1 255.255.255.0

duplex auto

speed auto

!

interface FastEthernet0/1

description LINK

ip address 10.3.3.2 255.255.255.0

load-interval 30

duplex auto

speed auto

!

interface BRI0/0/0

no ip address

encapsulation ppp

dialer pool-member 1

dialer idle-timeout 60

isdn switch-type basic-net3

isdn point-to-point-setup

no cdp enable

ppp authentication chap

!

interface Dialer0

ip address 10.7.7.2 255.255.255.0

encapsulation ppp

dialer pool 1

dialer remote-name ONE

dialer idle-timeout 60

dialer string 123456789

dialer load-threshold 1 outbound

dialer-group 1

no cdp enable

ppp authentication chap

ppp multilink

!

router ospf 1

log-adjacency-changes

passive-interface default

network 0.0.0.0 255.255.255.255 area 0

!

ip local policy route-map MY-LOCAL-POLICY

ip forward-protocol nd

ip route 0.0.0.0 0.0.0.0 10.4.4.1 track 1

ip route 0.0.0.0 0.0.0.0 10.7.7.1 254

ip http server

no ip http secure-server

!

!

!

ip sla 1

icmp-echo 10.1.1.1

timeout 1000

threshold 2

frequency 3

ip sla schedule 1 life forever start-time now

access-list 101 deny   ospf any any

access-list 101 permit ip any any time-range TRADING-HOURS

access-list 111 permit ip 10.6.6.0 0.0.0.255 10.5.5.0 0.0.0.255 time-range TRADING-HOURS

access-list 112 permit icmp any host 10.1.1.1 echo

dialer-list 1 protocol ip list 111

!

!

!

!

route-map MY-LOCAL-POLICY permit 10

match ip address 112

set ip next-hop 10.4.4.1

set interface Dialer0 Null0

!

!

!

control-plane

!

!

!

line con 0

logging synchronous

line aux 0

line vty 0 4

password cisco

login

!

scheduler allocate 20000 1000

time-range TRADING-HOURS

periodic weekdays 8:00 to 18:30

!

end

Router2: Edge router (callee)

------------------------------------------------

version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname ONE
!
boot-start-marker
boot-end-marker
!
logging buffered 10000 debugging
enable password cisco
!
no aaa new-model
memory-size iomem 25
clock timezone EET 2
clock summer-time EEST recurring last Sun Mar 3:00 last Sun Oct 3:00
no ip source-route
no ip gratuitous-arps
ip cef
!
!
ip auth-proxy max-nodata-conns 3
ip admission max-nodata-conns 3
!
!
!
isdn switch-type basic-net3
!
!
username ONE password 0 cisco
username TWO password 0 cisco
!
!
!
!
!
!
interface Loopback0
ip address 10.1.1.1 255.255.255.255
!        
interface Tunnel1
ip address 10.4.4.1 255.255.255.0
ip ospf network point-to-point
keepalive 10 3
tunnel source FastEthernet0/1
tunnel destination 10.3.3.2
!
interface FastEthernet0/0
description LAN
ip address 10.5.5.1 255.255.255.0
duplex auto
speed auto
!
interface FastEthernet0/1
description LINK
ip address 10.3.3.1 255.255.255.0
duplex auto
speed auto
!
interface BRI0/0/0
description BACKUP ISDN
no ip address
encapsulation ppp
no ip route-cache cef
no ip route-cache
no ip mroute-cache
load-interval 30
dialer pool-member 1
dialer idle-timeout 60
isdn switch-type basic-net3
isdn point-to-point-setup
no keepalive
no fair-queue
no cdp enable
ppp authentication chap
!
interface Dialer0
ip address 10.7.7.1 255.255.255.0
encapsulation ppp
no ip route-cache cef
no ip route-cache
no ip mroute-cache
dialer pool 1
dialer remote-name TWO
dialer idle-timeout 0
dialer-group 1
no cdp enable
ppp authentication chap
ppp multilink
!
router ospf 1
log-adjacency-changes
passive-interface default
network 0.0.0.0 255.255.255.255 area 0
!
ip forward-protocol nd
!
ip http server
no ip http secure-server
!
ip access-list extended dial
permit ip host 10.7.7.1 host 10.7.7.2 time-range TRADING_HOURS
!
access-list 101 deny   ospf any any
access-list 101 deny   udp any any eq ntp
access-list 101 permit ip any any time-range TRADING_HOURS
access-list 111 permit ip 10.5.5.0 0.0.0.255 10.6.6.0 0.0.0.255 time-range TRADING_HOURS
access-list 111 permit ip host 10.7.7.1 host 10.7.7.2 time-range TRADING_HOURS
access-list 112 permit ip any any time-range TRADING_HOURS
dialer watch-list 1 ip 10.2.2.0 255.255.255.0
dialer-list 1 protocol ip list 111
!
!
control-plane
!
!
line con 0
logging synchronous
line aux 0
line vty 0 4
password cisco
login
!
scheduler allocate 20000 1000
ntp master
time-range TRADING_HOURS
periodic weekdays 8:00 to 18:30
!
end

I have managed so far to make it work with static routes. The thing is: how to make it work with OSPF?

Any help will be appreciated.

Thank you.

TIA, Nicos Nicolaides
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: ISDN Backup on GRE interface with dynamic protocol.

2 REPLIES
Cisco Employee

Re: ISDN Backup on GRE interface with dynamic protocol.

New Member

Re: ISDN Backup on GRE interface with dynamic protocol.

The issue was fixed with IP SLAs.

TIA, Nicos Nicolaides
966
Views
0
Helpful
2
Replies