Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN BRI Interface ?????

Hi

I want to test my bri interface of Cisco 2500 router, whether its ok or not ??

I have no shut the interface and it show

outer#sh ip int brief

Interface IP-Address OK? Method Status Protocol

BRI0 unassigned YES unset up up

BRI0:1 unassigned YES unset down down

BRI0:2 unassigned YES unset down down

Ethernet0 unassigned YES unset up down

Serial0 unassigned YES unset down down

Serial1 unassigned YES unset down down

Thanks

1 REPLY

Re: ISDN BRI Interface ?????

Hi

To test a port, you need to have a BRI line with you.

Which cisco router is that?I believe that since u have a 2500 series, you should have an S/T interface, in which you need to connect external NT-1 device.

=====----

For more configuration, you need to refer to following link.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fdial_c/fnsprt3/dcdbri.htm

Pls revert back if u have any problem.

Regards

JD

91
Views
4
Helpful
1
Replies
CreatePlease to create content