my customer has complained that Telecom has been charged them huge amount of bills for their ISDN BRI link in the month of July, August and most probably this month.When quried, the Telecom blamed this has being caused by the router configurations and the calls amounts represent every call made lasting about 21 seconds and in intervals of 9 seconds, sometimes 14 seconds all hours of the day.
The ISDN BRi link is between two sites (Site A & Site B) and is a backup link to a Leased line. This link has not been utilized ever since it was commissioned as we've never had any problems with the the Leased line.
Please look at the configurations of both sites, attached, and identify to me which line in the config is causing this to happen. I'm no expert in ISDN BRI.
I have looked at the configs that you posted and I believe that I see your problem. I would explain it with these points:
- the subnet on the dialer interface is 184.108.40.206/30
- the network statement under router eigrp is:
- so the subnet of the dialer interface matches the eigrp network statement and therefore the router is attempting to run eigrp on the dialer interface. And it is attempting to send eigrp hello messages over the interface.
- the dialer-group and dialer-list are a simple protocol ip permit. So the eigrp hello messages are interesting traffic and will bring up the BRI interface.
The solution to the problem is to change the dialer list so that it references an extended access list. In the access list you need to deny eigrp as interesting traffic and then permit other traffic. The access list might look something like this:
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...