Im having cisco 3660 router and one isdn bri line for dialup purpose.I cant able to activate layer1 and layer2 in isdn bri.I changed bri card cables ane NT box but im getting the same deactivated message on all the layer.Whay may be the problem?
Did you check your isdn line for the required volt? you need to make sure that isdn line is up, better check out with your local telco to make sure that your line is up and you are getting the required voltage to place a data call.
Also make sure you have data channel enabled on this isdn line, earlier days the telco dont seem to enable the data channel to use the line for data communication.
do check this and revert back, if you still not able to get the line up do post out your scenario which you are trying here with the isdn line.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.