I have an ISDN backup circuit that is down on one side. I have a connection back to the Telco accordng to the NT1 LED and the Telco says they can see my NT1. I also had them come out to check the smartjack just by chance it was something odd. So right now I still do not have connectivity over the ISDN line with Layer 1 Deactivated. I have enabled debugging of events and q921 but the only message I get when I clear the interface and shut/no shut is ISDN BR0: L1 persistent Deactivated. Anybody think this could be a bad card? Any help would be appreciated.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...