My question is how to make a router to redial after layer 1 issue (like disconnecting isdn cable), i have a proble when network provider disconects, and router doesn't connect again. Please refer that i have only 3 semster CCNA course knowledge. Please help....
I don't think that is a IOS version problem but it can be. Ios version in that cisco 1801 router is:
Version 12.3(8r)YH8, RELEASE SOFTWARE (fc2)
and it is not an old release i thik?..?
Any ideas what could be wrong with this config, i look up the internet for solutions but nothing work.
Problem is when i disconnect the isdn interface removing the wire from port, and when i plug it again nothing happens. Only output shown up here. My Telco is Telekomunikacja Polska - maybe that is a problem :)
ip nat inside source list 100 interface Dialer1 overload
access-list 100 permit ip 192.168.1.0 0.0.0.255 any
access-list 100 deny ip any any
dialer watch-list 1 delay route-check initial 10
dialer watch-list 1 delay connect 10
dialer watch-list 1 delay disconnect 10
dialer-list 1 protocol ip permit
line con 0
password 7 xxxxxxxxxxxxxx
line aux 0
line vty 0 4
password 7 xxxxxxxxxxxxxxxxx
line vty 5 193
password 7 xxxxxxxxxxxx
Now i've noticed that router is sometimes dialing after i plug out the wire and plug in again. load treshold is working correctly but no idea why i cannot ping wan Ip's from the router and from the host also....
Maybe i will try to upgrade IOS and see what will happen...
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...