I'm having issues making a connection with my backup ISDN line. I'm enclosing a couple of show commands. I think the bold text might be the issue since I don't see that on any other devices that are working correctly.
Does that indicate an issue with the carrier?
xxx#sh controller bri
BRI unit 4:BRI unit 4 with U interface:
Layer 1 internal state is ACTIVATED
FPGA version = V6
FPGA create = 09/02/18 24
Layer 1 U interface is ACTIVATED.
External S/T is DEACTIVATED - Requesting Timing
ISDN Line Information:
Last C/I from ISDN transceiver:
Last C/I to ISDN transceiver:
Last C/I from ISDN S bus transceiver:
Last C/I to ISDN S bus transceiver:
Current EOC commands:
RTN - Return to normal
Received overhead bits: AIB=1, UOA=1, FEBE=1, DEA=1, ACT=1
Errors: Receive [NEBE]=0, Transmit [FEBE]=0
xxx#sh isdn status
Global ISDN Switchtype = basic-ni
ISDN BRI0/1/0 interface
dsl 4, interface ISDN Switchtype = basic-ni
Layer 1 Status:
Layer 2 Status:
TEI = 104, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
TEI 104, ces = 1, state = 6(not initialized)
spid1 configured, spid1 sent, spid1 NOT valid
TEI Not Assigned, ces = 2, state = 1(terminal down)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...