When issue "show interfaces bri0" it shows "Up and Up (spoofing)". Why spoofing? Is that because the interface is not really up but it has dialer rules set to the interface and ready to be up? What if there is no dialer rule setup? Will it show as down?
The reason the demand circuit keeps bringing up the link is because when the Layer 2 goes down after the idle timeout expires, the whole interface goes down. But in the case of BRI or PRI, when one of the channels goes down, the interface still remains up (in spoofing mode). To solve the problem you must configure a dialer interface because it never goes down. A dialer interface remains up (in spoofing mode).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...