Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN issue

HI,

I have a PRI line whcih is newly configured, but the controller is going up and down. Is it because of the configuration issue or the hardware failure. The clock is set as external.

4 REPLIES

Re: ISDN issue

HI, [Pls RATE if HELPS]

Refer this Link below for troubleshooting"

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00801509d7.shtml

Hope I am Informative.

Pls RATE if HELPS

Best Regards,

Guru Prasad R

New Member

Re: ISDN issue

Thanks Guru Prasad,

I have done the configuration, but the controller E1 is going up and down. Its not stable.

Re: ISDN issue

HI, [Pls Rate if HELPS]

Refer Link below and Troubleshoot the E1 Layer1 Issue:

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800fb754.shtml

Hope I am Informative.

Pls Rate if Helps => Use the Rating System.

Best Regards,

Guru Prasad R

New Member

Re: ISDN issue

Thanks Guru Prasad,

The controller came up after I changed the framing and CRC commands and its stable.

Eldo

108
Views
3
Helpful
4
Replies