isdn point-to-point setup

[dragec]

I am using ISDN for backup and never used this command. I have one router that stops making isdn calls and I have this command under bri0/0. When I delete it and reboot router ... this command is there again. I am usin point to multipoint isdn connections. Why cannot I delete this command?

[sundar.palaniappan]

Can you post the config of bri0/0?

[globalnettech]

Hello,

according to the usage guidelines of the command, it applies only if 'a static TEI has been activated with the "isdn static-tei" command'.

If you do not have that command configured the ' isdn point-to-point setup' line will be there, but has no effect. You also cannot delete it from your configuration...

HTH,

GNT