Same configuraions work just fine for me ,make sure you dont have any access list enabled on the US end .Try adding dialer-list 1 protocol ip permit in global config mode & dialer map ip x.x.x.x name test 01191xxxxx (this should be the phone no of the other end)
Try to ping the pri interface ip to bring up the session .
if any issues send the debugs ppp negotiation out put of both side
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...