Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN PRI with a VWIC-1MFT-T1?

Hello all,

We have a VWIC-1MFT-T1 on a 2821, and have a ISDN PRI circuit. The purpose for this circuit is a failover for remote locations in case their primary link goes down. I was told this VWIC card will work for what we need.

Unfortunately, I have looked everywhere (including Cisco) for configuration guides or examples with no luck. Apparently this is not a common way of working with ISDN PRI.

Is there anyone in a similar scenario? If so, can someone please provide configuration examples or instructions? Thanks,

1 REPLY
Hall of Fame Super Gold

Re: ISDN PRI with a VWIC-1MFT-T1?

Hi,

Support for Data PRI on VWIC-1MFT-T1 has been added to IOS only recently. You would also require PVDM2 modules and this can be incovenient.

This is the configuration guide:

http://www.cisco.com/en/US/products/ps6706/products_feature_guide09186a00805fe293.html

The alternative is to use NM-xCE1T1-PRI that would not require nothing of the above.

hope this helps, please rate post if it does!

275
Views
0
Helpful
1
Replies