Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

isdn pri

i had a cisco 3845 router,it is central router. i was took a isdn pri E1 line, it was the backup of leased line E1.

i had connected 30 branches(cisco-1841) via ch-E1 64Kbps speed backup of isdn bri.

how to configure my central and branch router isdn lines with DDR?

2 REPLIES
Silver

Re: isdn pri

DDR provides network connections across the Public Switched Telephone Network (PSTN). Traditionally, networks have been interconnected using dedicated lines for wide-area network (WAN) connections. With DDR, you can use modems, Integrated Service Data Network (ISDN) terminal adapters (TAs), or integrated ISDN capabilities to establish low-volume, periodic network connections over public circuit-switched networks. You can also establish dial-up connections over X.25 or Frame Relay packet-switched networks by using LAPB, X.25, or Frame Relay encapsulations.

The following protocols can be routed over DDR: AppleTalk, Banyan VINES, CLNS, DECnet, IP, IPX, and XNS

Refer the following URL for more information

http://www.cisco.com/en/US/tech/tk801/tk133/tech_configuration_guides_list.html

Silver

Re: isdn pri

Hi Raj ,

Can you confirm me like you have 30 branches in differnet locations with isdn bri as a back up for leased line.

How is the setup.

Is it like below.

3845 -----(1841)branch 1

|

-------- (1841)branch 2

--------- (1841)brach 30..

username router1 password XXXX

...

...

...

username Router 30 password XXXX

3845 config:

controller e1 X/X

framing crc4

linecode hdb3

pri-group timeslots 1-31

**Range is from 1 to 31.

interface serial slot/port:23

encapsulation ppp

dialer-group 1

dialer pool-member 1

ppp authentication chap

Create 30 dialer interafaces for 30 branches.

Int di1

ip address XXXX

encapsulation ppp

dialer-group 1

dialer remote-name router1

dialer idle-timeout 300

dilaer load-threshold 120 either.

dialer caller XXXX (isdn no of Branch 1)

dialer pool 1

ppp authentication chap

ppp chap password XXXX

ppp chap hostname XXXX (3845 hostname )

ppp multilink

dialer-list 1 protocol ip permit.

...

...

...

...

int di30

.

.

.

brach router 1

username XXXXX(3845 router name) password XXXX

int serial 0

ip add XXXX

backup delay 5 120

backup interface bri0

int bri0

ip add XXXX

encapsulation ppp

dialer-group 1

dialer string XXXX (Pri no -3845)

isdn switch-type XXXX

ppp authentcation chap

ppp chap password XXXX

ppp chap hostname XXXX (brach router name)

ppp multilink

dialer-list 1 protocol ip permit.

Note: As soon serial interface of brach router goes down isdn will be activated within 5 secons.as soon as serail link comes up isdn will be disconnected after 120 secons.

Brach 2

.

.

.

brach 3

.

.

.

.

brach 30

.

.

.

.

Thanks,

satish

139
Views
0
Helpful
2
Replies