Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ISDN Problem when IP CEF/Fast Switching enabled

Hi,

I am on a ISDN dial to a remote router.

I encountered a problem whereby I cannot see the LAN segment over the remote router when CEF & fast switching are enabled on both the dialer & gigaEthernet interface. However, when CEF & Fastswitching are disabled on both the dialer & ethernet, it works fine. Have any1 encounter the similar?

1 REPLY
Hall of Fame Super Silver

Re: ISDN Problem when IP CEF/Fast Switching enabled

Hello Lum,

you should provide more details to get better help:

a) platform : what model is your router ?

b) IOS version

c) configuration of dialer, isdn and DDR

In general, in some specific rare cases I saw the need to disable CEF or fast switching usually with IPSec and NAT, but be aware that this has an impact on router performance.

What happens if you disable CEF and fast switching only on the dialer ?

Hope to help

Giuseppe

172
Views
0
Helpful
1
Replies