05-12-2008 10:40 PM - edited 03-03-2019 09:55 PM
Dear All,
isdn is backup at remote end
if leased line goes down.isdn want to fire automaticaly.so waht is the command for fire the ISDN automtocaly
05-12-2008 10:45 PM
Hi Sasi ,
At the remote end you need to configure below commands under serial so that ISDN will be fired in case of leased line goes down.
Int s0
backup delay 5 120
backup interface bri0
Thanks,
Satish
05-12-2008 11:09 PM
Dear sathish,
backup delay 5 means if leasedline goes down after 5min ISDN will Work..
05-12-2008 11:44 PM
HI SaiKumar, [Pls RATE if HELPS]
Refer Link below for a Cisco Document explaning on how to configure the Dialer Backup for the Serial Line.
Hope I am Informative.
Pls RATE if HELPS
Best Regards,
Guru Prasad R
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: