Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN

I have a backup tunnel bulit on the BRI interface. When i do a ISDN test call, the layer 1 shows as activating, but it gets deactivated soon after that. what might be the problem?

4 REPLIES

Re: ISDN

Hi Navneet,

I faced this issue sometime back and the reaosn was the change in the number to which I was calling. So can you confirm the same.

Also this could be due to mismatch user name and password. Dont forget to check that also.

HTH, if yes please rate the post.

Ankur

Re: ISDN

Hi

I would suggest to check out the Physical line voltage too to make sure that you are up with the physical layer first.

regds

New Member

Re: ISDN

Hi,

try changing the switch type..

sometime it will work or try changing NT-1.

Silver

Re: ISDN

If you are doing the ISDN Test Call command then all you will prove out is that the ISDN makes the call. The remote end will answer to it, however if you are using CHAP or PAP then your call will drop. The test call does not incorporate your interface parameters, just makes a test call...Please rate..

113
Views
0
Helpful
4
Replies
CreatePlease to create content