Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

ISIS filtering

Hi All

I am running an all L2 network and need to filter out routes received from one interface to be advertised through another.

how can this be achieved ? I am looking at TAGging received routes, but then how can I stop them from being advertised.

TIA

Sam

1 REPLY
Bronze

Re: ISIS filtering

This can be solved by configuring port security on the ports. You can use port security to block input to an Ethernet, Fast Ethernet, or Gigabit Ethernet port when the MAC address of the station attempting to access the port is different from any of the MAC addresses specified for that port. Alternatively, you can use port security to filter traffic destined to or received from a specific host based on the host MAC address

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a00800c65c3.html

110
Views
0
Helpful
1
Replies